Series 1 Documents

We're currently shipping Series 2 controllers so the user guide and technical reference provided on the this page are for reference for existing installations.  Many improvements have been made to the operation and indications of the controller and you can update your controller to use the latest firmware.  If you have done so then you can refer to the current User Guide and System Configuration guide and need only the Latest TR guide below.  The current user and config guide references to the "Cycle Button" is the "Pump Button" on your system.

User Guide
If the Active LED comes on when you press a button, then this is the correct guide to use.
User Guide v5.pdf
Adobe Acrobat document [1.2 MB]
Latest Technical Reference for legacy systems
You can update legacy (series 1) controllers to have most of the same functionality and improvements as the current series by applying the firmware update (listed under the installation page). If you do so, then this is the technical guide to use. You can use the current configuration and user guides after the update.
Technical Reference S1V7.pdf
Adobe Acrobat document [2.6 MB]
Series 1 Technical Reference
Everything you need to maintain a series 1 automation controller. You have a series 1 controller if the Active LED blinks a few times before the system starts positioning the flush valve. These controllers used 2 boards instead of 1.
Technical Reference v6.pdf
Adobe Acrobat document [2.8 MB]
Print Print | Sitemap
© 2019 Rainwater Automation